Help on horse and rider

[leesheridan]

I hope some one on the forum can do better than I can. I have a good fried that has been asked to bring some of his Winchester collection to the Cody museum and put them on display and I have tried so many times to get the Winchester horse and rider to look at lest half way good but I'm still frustrated. I would be grateful if someone could help with the png. I have scanned and worked with pictures of the horse and rider and I'm still stuck. All I need is the horse and rider with out their lettering.
thanks, Mike

[eelamb]

Mike check your email

[leesheridan]

Ed, what a great job!!!!!!!!!!!!!!!
thanks, Mike

[easybuilt]

Great job Eddie!

[ladjr]

That is a great job. Did you use the new software.

Leo

[gashawk]

For give my camera, just carved this two weeks ago.

[CNC Carver]

Nice work on the Winchester Spirt Logo Sign looks good!

[eelamb]

Ladjr, no I am not a tester. Gashawk, nice sign.

Thanks guys for the comments. This was a quick job, took about 30 minutes. Would have been a lot better if I had about 2 hours to spend on it.

Edit: This is available via PM, send me your email.

[bjbethke]

I hope some one on the forum can do better than I can. I have a good fried that has been asked to bring some of his Winchester collection to the Cody museum and put them on display and I have tried so many times to get the Winchester horse and rider to look at lest half way good but I'm still frustrated. I would be grateful if someone could help with the png. I have scanned and worked with pictures of the horse and rider and I'm still stuck. All I need is the horse and rider with out their lettering.
thanks, Mike

Will this work? It's hard to find a good image to make a pattern.

[eelamb]

Decided to revisit the winchester horse and rider and add some details. Here is the results.