I caught a blurb in a thread recently but figured I would post here. I already purchased the Pattern Editor software.
Can I purchase the probe separately minus the PE software price?
Thanks,
I caught a blurb in a thread recently but figured I would post here. I already purchased the Pattern Editor software.
Can I purchase the probe separately minus the PE software price?
Thanks,
Bill Brooks
Henrico , VA
Printer, Zymurgist, Carvehead
Machine One - Version B, Carvetight upgrade and a Ringneck Blues Dust collector www.ringneckblues.com
Machine Two - 5th Anniversary Version C, Rubber Belts and a Ringneck Blues Blues Dust collector
The answer has always been no, but I'm asking again.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
i thought cw was in the buisness to make money
just look at his face how can any one refuse..
denny
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Certainly if I break my probe, I can buy a new one. Can't I?
Certainly.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Priceless.... YEP...
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Is the probe registered in any way? I would think that PE is the only part registered. Since the probe is not connected to the PC.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
PE software isn't transferable - seen lots of probes for sale here in the past - usually can't sell them 'cause they don't come with the software - but since you have that, sounds like you're a buyer for a used probe....
Livin' Life
Lovin' My Carvewright