Stallions Door Header

[badbert]

I wanted to carve something different for my entry door. I used some free patterns and put together a western theme. I have not carved it yet. I just wanted to share the MPC with everyone. To try to give something back. The stallions are from Pratyeka's grayscale post. Thank you Pratyeka! The rope pieces were from the pattern sharing depot. The MPC is 3 mb too large to upload here. So I uploaded it to web storage for free downloading!

http://www.mediafire.com/?zido5dh1v05jl

[tierman]

Looks great. A lot of action.

[LittleRedWoodshop]

Awesome pattern ... I am looking forward to carving it.

[henry1]

I like that and a good ideal for the corners thx

[Bigtyme]

Looks great....should really set off your entry door...

[mtylerfl]

That is going to be very impressive for your entry! Please post a photo or two of the finished installation. We will enjoy seeing it!

[dltccf]

I just started carving the stallion door pattern today. BTW, I put a 1/8 in feather on the outside box and set bit optimization to best and it took about an hour and a half off the projected carving time.

dave

[badbert]

I just started carving the stallion door pattern today. BTW, I put a 1/8 in feather on the outside box and set bit optimization to best and it took about an hour and a half off the projected carving time.

dave

Great! Please post pics, when you are done!

[liquidguitars]

very cool Nice job...

[henry1]

I wanted to carve something different for my entry door. I used some free patterns and put together a western theme. I have not carved it yet. I just wanted to share the MPC with everyone. To try to give something back. The stallions are from Pratyeka's grayscale post. Thank you Pratyeka! The rope pieces were from the pattern sharing depot. The MPC is 3 mb too large to upload here. PM your email if you want the MPC.

You have a private message