-
ok i just did the paper test and the reading went up to about 130. i noticed a few things while doing this;1 when i prompted to measure board the z axis moves over to the edge of the board when i checked the sensor reading it said zero i then moved the z axis over manually and it registered the 125-130( without the paper it was barely fifty now) this was on 1 inch thick walnut rollers checked compressed i then tried some 3/4 inch pine and only the back roller compressed sometimes it will find the walnut and continue to measure the board but the pine will never register as being loaded
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules