Originally Posted by
Azpark
Can't get my machine to jog to position. I have a 13"x5" board loaded and the carving is 1"x1" . It will let me jog about .05" and thats all. I have looked back at some 2008 posts about jogging but nothing has helped. I was hoping to put the carving esentially any place on the board.
Any suggestions ?
thanks
This little tid-bit is from the machine manual. It is accessed via the Designer software using the HELP button.
" Also it is important to note that the machine knows the size of the material loaded and the size of the project being carved. It will not jog to a starting corner that will position any part of the carving outside the boundary of the loaded material."
When you bring up the PDF file, click on EDIT > FIND, and type the word JOG. You may then walk through each instance of the word in the text.
AskBud