I remember reading in the forums awhile back where you can purchase traction belts from a 3rd party just by ordering by size. I can't seem to find that post again. Can someone point me in the right direction.
Thanks
I remember reading in the forums awhile back where you can purchase traction belts from a 3rd party just by ordering by size. I can't seem to find that post again. Can someone point me in the right direction.
Thanks
Morton
look in the column on the right. I have order 2 sets from them in the past and they work great.
Have one set on my carvewright now and the other are spares.
I ended up calling them than ordering them online.
I think I payed $30 shipped for 2 sets.
http://carvebuddy.com/links.html
Last edited by jaustin; 06-01-2012 at 12:08 AM.
John
I think this is the link you are looking for
http://forum.carvewright.com/showthr...traction+belts
Thanks, I actually did find that thread, but I did not read it thourghly to see the link so your help is much appreciated.
Morton
So I just went to go buy some of these and the link says to specify "j". I filled out the info but saw nowhere to do that. Any ideas?
Sent from my Droid using Tapatalk 2.
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
Try this place, I believe the belts are under 10 each. I here all you have to do is tell them it is for the CW, and they know the size.
http://customsandingbelts.com/
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
That's the same link in the end. I am just going to order them knowing the dimensions. I was just curious why you were supposed to pick j. I am going to call them I think.
Sent from my Droid using Tapatalk 2.
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
I orderd from Platte River Engineering (Woodworker's Supply) 15-13AO120J I bought 8 @ $4.80 EA $46.35 shipping handling tax phone 1-800-831-6066 just ask for CarveWright belts. They seem to work ok
thanks so much!
karl