Troubleshooting PDF's

[911guy]

Here you go.

[911guy]

Found this out the hard way. My flexshaft melted with 52 hours on it. Called LHR, said the truck housing has to be lubed after 20 hours.

[Jeff_Birt]

Here is a link to the Z-pack replacement PDF.

http://www.carvewright.com/downloads...e%20z-pack.pdf

[pkunk]

This is in 3 separate PDF's because of forum size limitations. I broke the 1 mb PDF into 3 smaller PDF's.

[tomkattogether]

Hope this helps some....

[tomkattogether]

-More PDF's

[tomkattogether]

more PDF's

[tomkattogether]

more PDF's

[woodie]

Ok. I hope I can describe my problem before my brain runs out of words. On the last several carves the cut motor has been speeding up and slowing down. I read several posts before where it was stated that their machine did the same thing, so I thought nothing of it. Well, the last carve I tried it started out fine, then about 3 minutes into it, it sounded like a car running out of gas. Going at what I would say a normal speed, and then it slowed way down, then speeded up, slowed down, and then stopped. The Y and Z motors (back and forth, up and down functions) where still operating. I called LHR and they had me do some things and it started (they were listening to it on the phone). It ran for about 3 minutes and started doing the same thing as before. They sent me a cut motor, still same as before( speed up slow down finally stop). Then they sent the little green circuit board ( I don't know what it is called). Still no cure. Now they sent me a power pac. No change, Only now it runs for about a minute and stops, everything else keeps on running. I am hoping someone who might have had this problem would know of a cause for this problem and offer a solution. Thanks Woodie

[Digitalwoodshop]

The only thing left is a loose Right Side cover Switch....

AL