MPC to large to upload, pic of project below, Xmas gift for a daughter. When I uploaded it the upload gave 9 1/2 hours on Best. Got a late start and when it showed 90% after the 9 1/2 hours late last night I decided to finish this AM. Hit the Stop button and closed up shop. Went in this AM, machine looked same, had the same 'Hit Enter to Proceed or Stop to Abort' message as when I stopped it.
Hit the Enter button and to my surprise got Fatal Error ( 3)! on the display. Keypad has gone dead, tried the Enter button first hoping it magically would work, then fiquiring I was up the creek tried the Stop button. Haven't turned it off yet or removed the board, waiting until I get over the frustration. Anybody have any experience with this error?