When I started a project, the LED panel said "please close lid". The lid is closed, I checked the connections to the safety switch, and they appear to be connected. How do I get the switch to function correctly so that I can start a project.
Doyne
When I started a project, the LED panel said "please close lid". The lid is closed, I checked the connections to the safety switch, and they appear to be connected. How do I get the switch to function correctly so that I can start a project.
Doyne
the switch on left side you might have to blow some air into it that might help
Henry
Every one has a photographic memory. Some just don't have film.
Doyne,
type "please close" in the search window (including the quote marks since there are two words)
Ken,
V-1, 2, & 3
When the People fear their Government, there is Tyranny.
When the Government fears the People, there is Liberty.
- Thomas Jefferson
You must be the change you wish to see in the world.
- Mohandas Gandhi
The best suggestion is blow out both switches and check if there is anything lodged in the switches.
Leo Davenport
Enjoy Life Carve Something everyday
I have blown out both switches, and the message "Please close cover" still appears in the LED Panel. Can the switches be bypassed? There are 2 white wires that are connected to the leads to the switches. What would happen if those wires were connected. Would this bypass the cover switches?
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I had to replace the spindle flex assembly. When I removed the top cover of the machine to replace the assembly, the connectors on the right side of the machine behind the cut motor assembly pulled apart. After replacing the assembyl, and reconnecting the wire connectors, and attatching the cover, I turned the machine on and the "please close cover" error message appeared.
When you put the cover back on did you re connect the left side (key board side) wires to the small circuit board behind the Y rail? These are the wires for the "close cover" switch...
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
I do not think those wires were disconnected. I will take the top back off to check. Thanks for the Help Floyd.
Doyne