I need help on placement of a design on my board.
How do I rotate it to put into the right area of my board.
Thanks! I know this may be crazy question but I am fairly new to this,
Thanks again!
Junior Member
Rotate a design on board?
I need help on placement of a design on my board.
How do I rotate it to put into the right area of my board.
Thanks! I know this may be crazy question but I am fairly new to this,
Thanks again!
In Memoriam
It is going to depend upon what needs rotated!Originally Posted by CLARKSCUSTOMDOORS
We would be better able to give good advise, if you attached your MPC.
In the meantime, my "Download" link below has 3 lessons where the titles begin with the words "Rotate".
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Senior Member
Click on the pattern, then right click the mouse, go down to rotate and choose which way to rotate your pattern 90 left, 90 right or 180
Junior Member
Thank you so much for your help. I will check out your downloads and hopefully be able to figure it out.
Posting Permissions
Reply With Quote