are patterns sized to a particular size, or can i resize to what i want, when i size the pattern it goes back to the smaller size.
thanks
amundo
are patterns sized to a particular size, or can i resize to what i want, when i size the pattern it goes back to the smaller size.
thanks
amundo
They all do have a set size but yes the patterns can be sized to what ever you need. Now I am assuming you are talking about doing this in designer and not the pattern editor.
First you must make sure the pattern is highlighted by clicking on the pattern on the board or in the view list. You should get a whit box around the pattern. Click and hold the mouse button on one of the red dots on the corner and then drag out or in to size. You can also type in the size in the dimension box.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
But if you type the size into the dimension box, the ratio will stay constant. If you drag a corner the ratio will also stay constant. If you want to change just the length or width, grab that edge and drag. For inatance, a corner pattern on a box top - put it in one corner, drag the horizontal edge to the horizontal center and the vertical edge to the vertical center, then mirror it in all four corners.
Clint
i have done what all has said, but a example would be the bird design, it appears to be 5 wide x 15 tall. that appears to be a fixed size.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29