Well, I'm in the middle of a carve... and I do what I KNOW I'm not supposed to do and use my ever so handy laying right there shopvac to get some dust off the carve. I see a spark... (dangit) but things keep carving. A couple of minutes later I notice that the LCD is blank with some little boxes showing. I was able to change bits and just hit "enter" to get the carve to continue (it is doing so now) and will try to reset the power when this carve is done.

1. What are the chances that the LCD will reset and be ok?
2. If it isn't ok, but the carve is continuing, what are the chances that the computer is fried?
3. If it is the LCD, what is the quickest method to get a new one? Unfortunately, the LCD is broken on my spare parts machine too...

Advice is appreciated, and yes... I'm a big dumb dummy for doing what I did with the shopvac...

Lawrence