Coke bottle

[normd]

A friend asked if I could carve a coke bottle relief piece to replace a missing doot handle on a coke cooler (like you would see in a market by the registers) I thinking 2' x 7" x 3/4 . I have no luck greating a file to carve this. any help would be appreciated
Normd

[AskBud]

A friend asked if I could carve a coke bottle relief piece to replace a missing doot handle on a coke cooler (like you would see in a market by the registers) I thinking 2' x 7" x 3/4 . I have no luck greating a file to carve this. any help would be appreciated
Normd

This Pattern Sharing link has two PTNs and one JPG.
AskBud
http://forum.carvewright.com/misc.ph...chments&t=2046

[jpaluck]

I made a nice one a while back..just looked on my server for it to repost but cant find it...if you look in the pattern sharing thread it's there somewhere

[jpaluck]

Here it is..found it..thanks for the link Bud. I have a bad habit of making patterns and then forgetting where I put them on my computers..I have 4 drives that I save things..so I confuse myself quite a bit