Pattern sharing depot

[Ike]

does anyone have a pattern or mpc that i could use? thanks in advance

Try these!

[dsw3]

thanks ike those will work fine

[BobHill]

U R 1 up on me I dont see any samples.

I looked around their forum they were talking about a way to use or make vector files.

Hess,
Sorry to take so long to reply. Did you find the MeshCam demo sample files? If not, check PROGRAM FILES\MESHCAM2\SAMPLE FILES. There are 3 raster files and one STL file there.

Bob Hill

[LollyWood]

Not good at 2d yet...bit more practice. Fairly good w/ vectors. Inspired by our good friend Ken. (Kenm810)

[CraigR]

Here is a sexy little vampire woman for Halloween if anybody wants it.

[BobHill]

Thanks for the pattern, Craig, but my wife won't let me play with those kind of Haloween people any more, darn it.
Bob Hill

[skeeterman]

is this a trick ,,,, or ( Treat)

[Elm]

This egg and dart molding was scanned from a small piece from my friend's circa 1900 house. Most off the shelf egg and dart moldings these days are not routed very deep. We needed to replace a 4 foot section. All worked well, but I did need to plane down the back side a bit for an exact match. I used poplar, but had some chip out on the dart stems. Since this was painted over, MDF may have worked better. He had price quotes from commercial mills that almost matched the price of the Carvewright.

[hess]

Here is a sexy little vampire woman for Halloween if anybody wants it.

now thats my kind of vamp and the wife likes her too

[robbrigg2]

Here is one I did.. not happy with the picture quality but it was the best that I had at the time.... I think it's funny though.

Robert

http://www.mediafire.com/file/1mz2yzdnnnu/theduke.mpc