Carve Region

[racer]

I'm trying to help a Church I sold a new CW to with the front of there Church and need some help with this.
Fa, Paul wonts a edge around this . When I invert the carve region goes away. I need a 1/2" edge and the pattern inverted. Thanks for any help. John

[AskBud]

I'm trying to help a Church I sold a new CW to with the front of there Church and need some help with this.
Fa, Paul wonts a edge around this . When I invert the carve region goes away. I need a 1/2" edge and the pattern inverted. Thanks for any help. John

I'm not sure what you are looking for. Could you re-state your design wish. If you invert the pattern the design will be like a jello mold, rather than standing proud as normal. Do you want a edge that is lower than the pattern.
AskBud

[lynnfrwd]

Rather than stretching the pattern to fill the 7 foot span, you might consider copying and pasting to fill the space. That way the pattern is not skewed.

[lynnfrwd]

You could assign a cut path (flipped) and also Select a bit (3/8" straight) and inset it.

[racer]

Thanks for all the help I have talked with the Church and they put this one on hold till I can go up to the Church and talk.
Thanks John

[lynnfrwd]

Here they are inverted and not inverted.

Ok...I see your message now.

[chief2007]

Think this is how you want it - inverted with an edge,

Hope it helps

[Digitalwoodshop]

I am doing a Church Project too with Grapes... I made a Carve Region .1 deep and inserted the Grapes with medium draft.... Still working on the design stuff....

AL