Hi Guys
I'm trying to get the cut path tool to work in the software.
If I use the square or circle tool it highlights, but if I draw lines to
make a shape it won't highlight.
Thx in advance
Jeff
Hi Guys
I'm trying to get the cut path tool to work in the software.
If I use the square or circle tool it highlights, but if I draw lines to
make a shape it won't highlight.
Thx in advance
Jeff
Your lines must be connected to form a closed figure, or the line must leave the design board.
You will find two lessons in my "Download" link, below, with titles that begin with the words "Connected Lines". Essentially, you click on VIEW > TOGGLE NON ENDPOINTS, and drag one of the ends to where it connects with the other. The RED dot will GLOW when connected.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Jeff.
In order to get a cut path you have to make sure all "end points" are connected to make a closed path. In the "view tab" select "toggle non end points". It will show the red end points that are not connected. Zoom in on the area, click and hold on one of the red end points and drag it to the next/closest point. When connected the red end points will change to a star to indicate they are connected.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.