Beautiful work Lawrence!
Beautiful work Lawrence!
Tom Watson
Two CW's and D.C.-Top Mount Insert @ Ringneckblues.com Get the dust out!!
50" X 48" PDJ Pilot Pro CNC http://www.pdjinc.com
Check out my Facebook page for current carvings at http://www.facebook.com/signsinwood
Watsons Wooden Words http://www.signsinwood.com & Messages in Wood http://www.messagesinwood.com/
Imagine the Helmet Case with a line of Green or Blue Strip LED's on the top or bottom edge of the glass....
WOW... I have a Plotter Cutter too... They say it will pay for itself over and over..... If you get one that has a photo eye or LED Pointer, you can do things like print stickers and use the eye or pointer to put it back into the cutter and line it up with the registration marks.....
Another thing you can do like the glass is to apply it to the BACK of a Mirror and sand blast off the reflective and then paint with common latex paint.... They do it with a laser but the sand blast is doing the same thing.... I have seen some done in a few colors, lasering off the paint to add fine detail of another color...
Good Job !!!!
AL
LED lights on a reel.
http://www.ebay.com/itm/XMAS-Lights-...item41618f0703
Last edited by Digitalwoodshop; 03-10-2012 at 02:32 PM.
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Nice work.
Make the Cut software is a good software to use with vinyl cutters. I use it for paper die cuts.
I didn't expect to find this here. Haven't been here since 2007. I bought a Cameo about two weeks ago and it is still in the box. I have plans to get it set up this week. Looks like great fun.
Welcome Back... A Vinyl Cutter will pay for itself over and over... A GREAT Investment...
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
Make the Cut software is a good software to use with vinyl cutters.
What is it you don't like about the cream? I bought some a while back but have not used it yet.
Nice Job.
We've been using our Silhouette Cameo to cut stencils for air erasing. We are also using a sand blasting box and loving the whole process. I'm still using the Silhouette Designer software but hope to add MTC later.
Fun!