pattern help.

[bayea]

I have these two end pieces. they are for a stand. the two pieces should be exactly alike. both using only the 1/8" straight bit, mostly so i don't have to keep changing out the bit.

the SideSwordRt.mpc keeps asking for the 1/16" bit.

the SideSwordLft.mpc only ask for the 18" bit.

both patterns have a front and rear.
I have looked and looked and can not see any difference between the two.
I have done cut/paste from SideSwordLft to SideSwordRt to make sure everything is exactly the same size.
could someone help me out please.

SideSwordRt.mpc
SideSwordLft.mpc

[Old Salt]

Side rt has bit specified 1/8 side lf has set for 1/16 th
go to board settings and bit settiings

[fwharris]

You have a carve region so it will be asking for the 1/16 bit..

[bayea]

You have a carve region so it will be asking for the 1/16 bit..

but the right is also a carve region and it docent ask me for a 1/16 bit

[bayea]

Side rt has bit specified 1/8 side lf has set for 1/16 th
go to board settings and bit settiings

ah ha! so simple now that i see it. lol thank you!!