Results 1 to 6 of 6

Thread: Close Cover

  1. Default Close Cover

    Ran one board tonight and went to run the second and keep getting a close cover error on the screen. Nothing is stopping the cover from closing all the way and have tried turning off and then back on and still the same problem. Any advise??? Please and thankyou in advance

  2. #2
    Join Date
    Aug 2011
    Location
    Michigan
    Posts
    1,108

    Default

    There are switches on the left and right side of the cover hinge that are visible when the cover is open. I believe the switch on the left controls the "close cover" message. I usally blow compressed air (lightly) into each switch during cleanup and haven't had a problem...
    John
    www.jdmwoodworks.com
    Facebook Page: click FB button on web page

    Bessemer, MI (shop location)
    Lake Gogebic, MI (where I hang my hat)

    "He who wants by the yard, but gives by the inch, should be kicked by the foot"...

  3. #3
    Join Date
    Sep 2008
    Location
    Billings, Montana, United States, 112454482100538, Billings, Montana
    Posts
    34

    Default

    check the cut motor switch,it's on the right hand side.up underneath the top cover. sometimes it saw dust,so blow it of with compressed air. If you have alot cut hours on your machine ,you may have to replace the switch.

  4. #4
    Join Date
    Nov 2007
    Location
    Las Vegas NV
    Posts
    1,277

    Default

    I have found that ig you push a pencil in lightly, with the cover open, if the close cover goes out it is a dirt switch.

    Leo

  5. #5
    Join Date
    Feb 2008
    Location
    Indian Lake, Ohio - Rts 33 & 235
    Posts
    3,972

    Default

    Quote Originally Posted by ladjr View Post
    I have found that ig you push a pencil in lightly, with the cover open, if the close cover goes out it is a dirt switch.

    Leo
    It could also be that the switch just needs to be moved fordard/outward slightly. You did not state which chuck you have. It could be a vibration issue, also check the tab, on the clear cover, to be sure it is a mirror of the one on the right. Another quick check would be to run a strip of masking tape down the clear cover, near the keyboard side, and secure it to the black frame. If this resolves the problem, move the switch.
    AskBud
    AskBud Downloads =>> CLICK HERE
    Lesson added
    7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"

    CW Vacuum Head Project =>> CLICK HERE
    AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons

    More than 1250 AskBud patterns
    vvv-CLICK BELOW-vvv
    http://store.carvewright.com/manufac...ufacturerid=29

  6. #6

    Default Cover switch

    Need some help please. The close cover warning comes on but the switch is fine. Checked it with my ohm meter. It worked just fine last time I used it. Any ideas.
    Thanks
    Mike

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •