I got all of the bits with the system unfortunatley i cant tell them apart. can anyone direct me?
I got all of the bits with the system unfortunatley i cant tell them apart. can anyone direct me?
Page 35 of the owner manual gives a picture and description of each bit..
http://www.carvewright.com/2010CWweb...anual_C_SN.pdf
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Look on the store too.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Your carving bit has a tapper to it,endding in a 1/16 end. Your Cutting bit has a almost flat bottom, either size , 1/16, 1/8 or 3/16. They will be shown in the mannual.
Capt Barry