Very nice. How did you finish the "Last Supper"?
It doesn't matter how long we have been at this stuff, we are all "still learning".
Morton
Jerry they all look really good.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Jerry... all your projects are great. I really like the Last Supper and the... guess you would call them Greenmen. It's hard to tell but did you dome the faces onto the wood?
Looking great!
Viva la carve!
I just carved them in to the wood.. no dome. I'm going to carve 4 more facing opposite direction. I plan to put these on the 4 posts of our Pergula beside our pool. I think they're going to look good.. hope so anyway. Just light brushed some gray paint on the hair and beard to make it "pop" a little. Then just added some clear coat.
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Jerry...I'm sure Doug and Sharon give you an "A"! Those all look great! (I really like the wispy hair highlighted on the carved faces - nice effect!)
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
Great job on all of the Jerry!
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
I like them, especially the faces.
Clint