Yes, but they have used loctite and it will require heat to loosen the allen screws.
Yes, but they have used loctite and it will require heat to loosen the allen screws.
very cool !! thanks. i ordered my set
Ok, I ordered them. Picked up both sets for $128 with shipping. That's a pretty good deal compared to the $399 it is listed at CW.
Connie,
They are the decorative bits a long with the V60/V90 and such.
Happy Carving
Robert D.
rcdages
CarveWright START U Team Member.
The mightiest oak in the forest is just a little nut
that held it's ground.
I finally went to the site. 11 piece full bit set divided in two. Yep good deal. Go for it before they are gone.
Sent from my iPhone using Tapatalk
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
Great deal! Now I have 2 sets.
Lee
Pop's Fix It Shop, We won't make it any worse.. Using "A" machines 1.187 1.188 ,2.007, 3.103
2 Machines no waiting.
This is a good deal. I waited until I recieved them to post the info because I didn't want to post bad info. The bits come with a magnetic case that fits in the side of the machine. Plus if you don't need the QC adapters you can sell them and reduce your cost even more.
Can you take the collar off and use them with the CarveTight?
Moeron
Morton
YES
On the 1/4 inch shank bits, you loosen the screws. I put mine in a 350 degree oven for about 15 minutes and then handle with an oven mitt or pliers (just to make it easier). On the 1/2 inch shank bits, you just loosen the nut, which is just above the head of the cutter (no heat required).
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
just ordered mine today. probably won't use the decorative bits in the carvewright, but good to have them just in case. and at a great price. any chance of posting a pic of the magnetic cases the bits come in?