can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .
can i do a "cut out" of a object if the board thickness is a little over 1/4" ? it is a cut out only. . . .
I use a sled for these cutouts-- just make sure that when the software asks you, tell it you will use a sled (manual jig)
Lawrence
a sled with a carrier board or can i use just rails?
I've used Sleds and Carrier Boards to carve and cut out projests down to 1/4" and 1/8" with no problems
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Hello,
The following Tips & Tricks shows how this can be done...
http://www.carvewright.com/downloads...cks_Sept08.pdf
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗
Michael !! LOL that is exactly what i was looking for !
Thank you, thank you, thank you!!!
n