Hi all,
is there some info on the defaults designer uses for each type of "toolpaths" it can produce and if possible for each "standard" bit?
Thanks,
Felix
Hi all,
is there some info on the defaults designer uses for each type of "toolpaths" it can produce and if possible for each "standard" bit?
Thanks,
Felix
I don't think this information has ever been released. For some operations the feed rate is a bit more complicated, i.e. when doing raster carving the feed rate is related to depth.
Happy carving , Jeff Birt
Check out www.soigeneris.com for CarveWright Accesories.
Home of the 'Carving in the Dark' back lit LCD kit!
Chapter 9 of the Carvewright Manual has detailed info about the bits.