Originally Posted by
chkorte
I’ve got the same error. Friday I did an edge sensor calibration and an X-axis calibration. Everything came out good. Yesterday I carved a small project to test out my new carrier board. Everything carved fine. Today I loaded a new project on the carrier board and get the edge detection error. The “board” is a piece of black corian, however I have taped the full length of the X and Y measurement points with white masking tape. The rails are all clean and I have wiped the board sensor clean. I completely cleaned the machine after the last carve. I even loaded just a piece of maple board and it measured it just fine. When I reload the carrier board with the corian I get the error again.