I have a unit here at Fort Sill nicknamed the Punishers, so of course their unofficial logo is the punisher skull. Any help would be greatly appreciated in getting a pattern of the skull. Thanks in advance for any help.
John
I have a unit here at Fort Sill nicknamed the Punishers, so of course their unofficial logo is the punisher skull. Any help would be greatly appreciated in getting a pattern of the skull. Thanks in advance for any help.
John
John will this one do.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
That looks pretty good. Is there a way to get the "teeth" to the same height as the rest of the skull. After carving these will be cut out and mounted at several different locations. I.m afraid that if I ddo the skull out of 4/4 stock the teeth section will be too fragile.
Sure, what thickness do you want the entire skull. Current is .25 thick, so if you are going to cut it out, you may want it to be a deeper carve for the 4/4 stock.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Like Eddie mentioned, carved a little deeper in 4/4 looks good, if you're still worried about it breaking
you might consider carving it with the grain of the wood you choose.
Last edited by Kenm810; 01-09-2012 at 03:28 PM.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Thanks guys. I will go ahead and give it a run and see how it turns out. I appreciate the help.
Does anyone have this patter that would be willing to share?
If you click this link, it will take you to the pattern. Just scroll down, click on download, then click the name that shows up and it will download for you.
http://lambswoodworking.com/products...id_product=258
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Eddie,
I don't believe I had seen those patterns. They are great looking patterns. I really like the tree of life one. I just made one that is similar.
Hope you've been doing well.
Oscar
Oscar, those are normally seen by those who have purchased from me. By me giving a direct link it shows 23 items in that category. All totaled I have over 130 free patterns on the site, again only available to some members. This cart does not take payments anymore now, so if anyone is ordering, they must email me and I will give them instructions. At some point I plan to take the cart down completely, maybe I will create a WordPress cart at some time, but most likely not.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie