How do I fix?
How do I fix?
EVERY TIME IT HAPPENS TO ME THE WINDOW ON THE BOTTOM OF THE z-TRUCK IS DIRTY.
if you put small mirror on the traction belt under the carving head,
you will get a pretty good look at the lens of the board sencer.
I use a fine painters brush and a little low pressure air to clean
mine after nearly every carving. I've only had to replace mine once
in 4 years due to damage to one of the screws.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Hello,
There is quite a lot of information posted here on the forum about troubleshooting the "clear board sensor" message. Using the Search feature, I found several threads that may be helpful (tip...when using search, enclose your search term in quotation marks...for example: "clear board sensor" )
Here is just one thread I found that might be helpful for you:
http://forum.carvewright.com/showthr...r+board+sensor
Michael T
Happy Carving!
╔═══ Links to Patterns & Resources for CompuCarve™ & CarveWright™ ═══╗