looking to make a plaque for friend who just had baby, needing a couple of ptns (Pacifier),( baby bottle), (baby shoes),( baby feet). wanting good 3-d ptns will pay, looked in pattern depot and could not find what i was looking for,
thanks steve
looking to make a plaque for friend who just had baby, needing a couple of ptns (Pacifier),( baby bottle), (baby shoes),( baby feet). wanting good 3-d ptns will pay, looked in pattern depot and could not find what i was looking for,
thanks steve
Start U Member
Baby feet in pattern sharing depot #256. Seen a pacifier in there too. Should be able to search for them. I've slowly been looking for some patterns to start with. I'm past 300 pages so far and still looking.
richard
You may have seen this, but just to be sure I'll add the link to page #4 of the pattern depot search for "baby". The plaque, or frame has two of the items.
AskBud
http://store.carvewright.com/search....=search&page=4
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Bud i purchased the baby pic frame about 2 hrs ago . it shows in red when i try to upload, may have to wait afew days before i can carve it, Richard i will look in the ptn depot for the ptns you mentioned, I am looking for Bottle , pacifier and baby booties as well as feet
thanks
Start U Member
Steve not really 3D, but you are welcomed to use them.
Rick
Sorry I didn't see you bought a pattern, still if you want any of the ptn's go for it!
Last edited by Ike; 01-01-2012 at 09:40 PM.
I just added shoes and a bottle to my addition to the Depot. They will appear in the next Pattern depot update this coming week. Try each one before you actually decide to buy. I see that Ike just posted a bottle.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
I have a baby bottle on my site, and have the other items in 3d on there if you want.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Just added the baby shoes to my site. You can add the baby's name to the bottom of one shoe. I used center line, and conforming, but you can use raster text.
Last edited by eelamb; 01-02-2012 at 05:11 PM. Reason: changed image
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
I went ahead and made the baby feet and pacifier, again they are on my site.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie