While the machine is running its carving the pattern as it goes across the width its going fine until it goes over the opposite end and carves not as deep...anyone knows what that could possible be? The lighter side is opposite the keypad side.
While the machine is running its carving the pattern as it goes across the width its going fine until it goes over the opposite end and carves not as deep...anyone knows what that could possible be? The lighter side is opposite the keypad side.
That is caused by the head not being level. A Stiff cold Machine when you crank it up and down it can skip a tooth under the machine where the gears transfer the crank to the opposite side.
Place 2 strips of paper on the board each side and crank the head down and pull the paper. If one comes out easy then the head is high.
You can use the bit and Z Data to measure to the board by touching the bit to the board by hand.
AL
Favorite Saying.... "It's ALL About the Brass Roller"..... And "Use MASKING TAPE" for board skipping in the X or breaking bits.
Follow ME on Facebook http://www.facebook.com/pages/Accoun...50019051727074
www.PoconoDigitalWoodshop.com
www.AccountabilityTag.com
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Ok Ill look into it now....
Checked it and one side with the paper came out. What do I have to do to correct this?
So what do I have to do to correct this?
Here is a PDF on how to level the head.
AskBud
http://www.carvewright.com/2010CWweb...level_head.pdf
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
That worked thanks!