Moved my compucarve from basement to shop prepared a litho project for a Christmas gift and the #### thing will not power on the keypad remains blank any suggestions to this fustrated novice?
Moved my compucarve from basement to shop prepared a litho project for a Christmas gift and the #### thing will not power on the keypad remains blank any suggestions to this fustrated novice?
Is the memory card inserted and the contrast knob on the keypad adjusted?
Last edited by PCW; 12-17-2011 at 05:11 PM.
No the memory card is not inserted yet could some connection become lose in a very short move?
Right on I knew the forum would have the answer I inserted the memory card and adjusted the contrast and now have a keypad will start the project and perhaps post pic of the result
Thanks Sooooo Much
Don
Make sure the machine is powered off then insert the card/turn the switch on. Unit will not display if the cards not in.
Great.... We all have done that at least once.
1 hour in on a 3.5 hour carve. My first attempt at a litho. Picked up some polyethylene cutting boards on closeout at the local Pamida. Set hight at 900 and depth at 0.4 with a board 7/16th inch thick on a sled. Didn't see where I could set the max mass depth but so far is going ok. Hope to post a picture of my completed project when done
Max pass depth? Are you talking about for the cut out? It is in the input screen/box when you are setting up the cut out.
Not sure on your depth and height setting but thinking that the 900 height might be to high. Good luck and waiting to see your results...
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
For 1/4" material the recommended settings are .180 depth and 450 height.
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.