Where the white circle is I need to make a round bottom groove about 1/2" wide x 1/8-3/16 deep.
I tried using the depth profile and it doesn't make it all around or it tapers around.
thanks for the help
Where the white circle is I need to make a round bottom groove about 1/2" wide x 1/8-3/16 deep.
I tried using the depth profile and it doesn't make it all around or it tapers around.
thanks for the help
Do you have a 1/2" ball nose bit?
RingNeckBlues
My patterns on the Depot
DC-INSERT It Just Sucks!
Proven to out perform all others!
Buy CarveWright
Colorado FaceBook Users Group
All patterns and projects that I share on the CarveWright forum are for your personal carving purpose. They are not to be shared, sold or posted on any other web site without permission from RingNeckBlues Designs.
Last edited by AskBud; 12-10-2011 at 07:22 PM.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
don't have a 1/2 ball nose bit?
will a 1/2 shank bit from the woodworking store work or do I need a carvewright one?
I do have a 1/4 in shank and a carvetight broken bit and holder?
but no press to press them out with
Last edited by jaustin; 12-10-2011 at 07:02 PM.
If you have a split collet the 1/4 inch shank, from LHR, will work.
If you get a bit somewhere else, make sure it is has Carbide cutters.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Just a router bit from woodcraft.
Trying not spend any more money right now if I don't need to.
l Figured out, going with just a 3/16 groove.
should be good enough for what i need it for.
Last edited by jaustin; 12-10-2011 at 07:20 PM.
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
If I'm reading it right, --- What about something like this
Last edited by Kenm810; 12-10-2011 at 08:10 PM. Reason: Added Ptn File
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails