Originally Posted by
Retrospek
Quite often the last few days when I try to carve a project, it asks for a bit. For instance, it will ask for the 1/8" cutting bit. Bit inserted, carriage moves to the left, when it moves to the right for the touch paddle, it won't go far enough right to make the paddle come out all the way. I have tried cleaning everything, and it works about 25% of the time, the other 75% it says it can find the bit. Rinse and repeat, over and over. If I open the lid, the paddle moves freely, the carriage is free of debris, everything looks good. When it does work, no other issues, but it's frustrating that I have to do it sometimes 4 or 5 times before it finds the bit.
Any suggestions on how to fix this issue? Thanks.
Go to www.carvewright.com > Support > Search Support bar > Type "Bit Plate" (or other relevant key word)- follow the troubleshooting sheet.
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!