Senior Member
Pics of probe
I mentioned in one of my other posts about the probe eating a plaster mold I had made. I was in too much of a hurry and didn't let the plaster cure for 4-5 days (like the directions said). This time a new mold, cured, & glazed is being copied now. Last is the plaster parrot, then the destroyed first one & a pic of the probe doing it's thing. I'll post here again when it's done in a couple of hours.
The 50-50-90 rule: Anytime you have a 50-50 chance of getting something right, there's a 90% probability you'll get it wrong.
Do it on a Mac.
Vietnam Vet '65-'66
Senior Member
As promised
A little late, but the scan took 1/2 hr longer than the LCD indicated. Then there was some noise that I had to cleanup, eat dinner, and get the post together. As it comes off the scanner.
Then as it will look on a piece of wood. I don't have a file yet that I will actually use.
The 50-50-90 rule: Anytime you have a 50-50 chance of getting something right, there's a 90% probability you'll get it wrong.
Do it on a Mac.
Vietnam Vet '65-'66
In Memoriam
I sure like the way your parrot turned out, Pkunk.
Bob
Senior Member
The probe still chewed up the clear finish on the plaster casting. It's not as gentle as I'd hoped. Still like to see someone try a clay piece.
The 50-50-90 rule: Anytime you have a 50-50 chance of getting something right, there's a 90% probability you'll get it wrong.
Do it on a Mac.
Vietnam Vet '65-'66
Posting Permissions
Reply With Quote