Very nicely done, I like the way it came out!
Very nicely done, I like the way it came out!
Thanks guys, and it is on my site.
I have been out all day. A building supply company was auctioning off everything. Thought I could get some good deals on lumber, but all the lumber they had was trim. I did pick up a bundle of 4"x.5" oak trim, 12' in length with 18 pieces in it for $10 (unfinished). But the prize was a new upright compressor, 7.6cfm, 5hp, 40 gal. I got it for $170. It runs very quiet and weighs a ton. It is still in the truck wrapped. Ice storm hit as I was about to leave, and the roads/truck everything is covered. Figured best to wait till daylight to try and get it unloaded. Tractor will used to unload it. Right now we have about .5" of ice out there, and it is still coming down, but temp is hovering right at 32 deg. so may not be much more than what it is right now.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Great looking box and man that weather sounds Coooolllldddd
Thanks John, and it was, the rain made it worse. Ice ended up between freeze and thaw, at about .25", and we got about an 1" of snow.
Well I have been at it again. Another box, this one is one my site already.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
what is the size of the box H W L
Henry
Every one has a photographic memory. Some just don't have film.
This one is:
inside 4.5x8.5x3" h
outside (base 11x7.5x4.5"H)
It is shallow, takes a board of 9x68"
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
thank you for the post, I am not ready yet got to get this project done dust collection set it up
Henry
Every one has a photographic memory. Some just don't have film.
Henry, and others, I have repaired the problem on my cart, where once logged in you could not see the categories. They are now there all the time.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Thank you nfor that have a nice day
Henry
Every one has a photographic memory. Some just don't have film.
Image of a couple of items I have been working on.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie