I came up with this. I used all the layer and curving and bumping techniques that I go over in my Gimp Tutorials, which are found in the 3rd party software forum: http://forum.carvewright.com/forumdi...Party-Software This was a pretty hard pattern to do.
Bull3.ptn
Alan
Here is one more to consider
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
You guys are amazing. Thanks for always taking the time to help out fellow carvers!
thanks guys im sure one of them will work. Sorry it took me so long to get back on here. thanks again
Cabinetdesigner, I decided to make another one, to clean it up some on the plaque and wording, and did this one from scratch using Moi and Zbrush.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie