I'm in need of a plain pattern of an arch. Flat on bottom, arch on top (Half circle).I need to be able to make it 1 FT high by 2 FT wide. My patterns still come out real jagged.
Thanks
Don
Junior Member
in need again!
I'm in need of a plain pattern of an arch. Flat on bottom, arch on top (Half circle).I need to be able to make it 1 FT high by 2 FT wide. My patterns still come out real jagged.
Thanks
Don
In Memoriam
Attach your MPC, so we see exactly what you need.Originally Posted by woodchip
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Junior Member
Sorry, I got rushed and deleted everything. Just got back from a show where I picked up to many orders and my head is spinning. Also my daughter in law is wanting me to post an album here. (I'm new to that also)
Don
Senior Member
You can do that in designer, Load a board image 12x24, use the arc tool and draw the arc starting at the bottom of the board the pull the arc to the top and then draw a line on the bottom of the arc to complete a loop. Add a carve region and group the pattern. You then can make your pattern with the group selected.
Hope this helps BJB
Last edited by bjbethke; 09-13-2011 at 02:03 PM.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.
Junior Member
BJB
Thanks, Thats perfect.
Don
Posting Permissions
Reply With Quote