Jerry I hope you mend up as good as before, and you are able to get back to your shop and back on here more often.
Greg, nice looking LItho's.
Senior Member
Jerry I hope you mend up as good as before, and you are able to get back to your shop and back on here more often.
Greg, nice looking LItho's.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Junior Member
I'm looking for lights and power supply for my litho. What is the cost for what you use? The Led's and power supply.
Leo
Senior Member
Leo, I purchased a 12 volt 1amp supply off ebay, (actually I purchased a group (lot) of about 20) came out to be about 2 bucks each, looks like a phone charge. The LED's I used came on a reel that had 300 lights for like 22 bucks. Not sure if this link will work but I saved it in my eBay account info. http://www.ebay.com/itm/350349873777...84.m1423.l2649
CJ
CarverJerry
ver. 1.188 Win 7- 64b with 6 GB ram @ 2.8Ghz and dual 1Tb hard drives. Rock Chuck & Ringneck vacuum system hooked up to a Harbor Freight large vacuum. Center line text, conforming vectors.
Posting Permissions
Reply With Quote