I was just messing around with the Designer one day and created these
I was just messing around with the Designer one day and created these
Last edited by SteveNelson46; 09-08-2011 at 11:57 AM.
Steve
Well.. it is quite apparent you have been holding out on us!! Keep the postings going, you have created some really nice stuff!
Doug Fletcher
Nice Job Steve,
I've been carving a few and collecting a few
Thanks for the Photos and Mpc file.
Ken
Ver 1.182 on XL Pro plus Ver 1.164 and 1.175 on Windows 7 Ultimate
It Never Fails * Till * You Say It Never Fails
Lots of work you have been keeping bus.,Steve. Thanks for the mpc. Capt Barry
the simple one is my favorite, but I like them both. Red oak and cherry?
Lawrence
Definately would like the mpc to the Fancy trivit please.
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"
Thanks Steve, for another project. Capt Barry
Thanks for the mpc, I love that simple one. At first I thought it was two carves, set off 90 degrees and glued up, but the mpc shows it as a two sided carve! Even better!!
Great job!
Craig