Doug, Now my head is spinning. Maybe its a good thing I need to go to work. Looking forward to the examples. Man I'm learning alot....
Don
Doug, Now my head is spinning. Maybe its a good thing I need to go to work. Looking forward to the examples. Man I'm learning alot....
Don
On this specific issue!
If you have a "Carve Area/Pattern" that goes to the very edge of your design/layout, you need to plan on how you are going to provide "Rails" for the top rollers to use.
The top rollers must stay elevated, or the machine thinks the board has left that roller and will abort in some way.
We usually keep any carve area 1/2 inch away from the top of our design, or plan on using a wider/taller board in the unit and Centering out project (DO NOT RESIZE WHEN ASKED). This allows for the needed rails as it carves. You, of course, still need the added length as stated before.
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29