Results 1 to 6 of 6

Thread: Message error (57)

  1. #1

    Default Message error (57)

    The machine is stopping in the middle of carving lettering. It says- Please ensure your designer software and machine firmware are compatible (57). I have run the progam before and it worked fine. I tried another project and same thing happened.

  2. #2
    Join Date
    Oct 2008
    Location
    Mars
    Posts
    286

    Default

    Corruption in the memory card. In most cases, formatting the memory card and reloading the firmware and project resolves it.

  3. #3

    Default

    How do I format the memory card?

  4. #4
    Join Date
    Feb 2008
    Location
    Indian Lake, Ohio - Rts 33 & 235
    Posts
    3,972

    Default

    Quote Originally Posted by raye321 View Post
    How do I format the memory card?
    While you have Designer activated, on your PC, and the card reader connected to a USB port, place the card back in the reader. Now, go to FILE > FLASH MANAGER > FORMAT. Once that is completed, re load your MPC (project).
    When you go to place the memory card in the CW, make sure it is turned off or you stand the chance of creating error codes or totally blowing your card/system. The same applies as you remove the card from the CW.
    AskBud
    AskBud Downloads =>> CLICK HERE
    Lesson added
    7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"

    CW Vacuum Head Project =>> CLICK HERE
    AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons

    More than 1250 AskBud patterns
    vvv-CLICK BELOW-vvv
    http://store.carvewright.com/manufac...ufacturerid=29

  5. #5

    Default

    So the machine should always be turned off when inserting or removing the memory card?

  6. #6
    Join Date
    Oct 2008
    Location
    Mars
    Posts
    286

    Default

    Yes, otherwise you take several risks that can cause things like shorting out the card or controller that would require a replacement.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •