hey friends, wood for 25 years, new to all this, very exited to meet and have a blast
Junior Member
newbie with questions
hey friends, wood for 25 years, new to all this, very exited to meet and have a blast
Senior Member
Welcome to the forum! Did you already get your machine? New? Used? Revision? There a lots of ways to get tripped up as a newbie, so be sure to read as much as possible, and when in doubt, feel free to ask here. This is a great and very active forum and everyone is willing to help in any way possible.
Doug Fletcher
Senior Member
Welcome Charles1964 to the forum, this is the best place to get help, advice or just good chat.
Where are you located in the big world?
Perry
My Shop 1044
CarveWright START U Team Member
V - 1.187 and 3.0 too
With the DC Insert," dust all gone"
CarveWright Customer Documentation http://www.carvewright.com/2010CWweb/maintenance.htm
CarveWright Tips and Tricks http://www.carvewright.com/2010CWweb/tips.htm
www.customcarvingsbyperry.com
I have often wondered why it is that
Conservatives are called the "right" and Liberals are called the "left".
"The heart of the wise inclines to the right, but the heart of
the fool to the left."
Junior Member
winona mn. USA
Junior Member
awsome, got my machine after reading all the good bad and ugly, and sure enough my card reader didnt work, but after that i have had all good
Junior Member
am i still here?
Junior Member
new to forums to
In Memoriam
Go here, and review the first seven links.Originally Posted by Charles1964
AskBud
http://forum.carvewright.com/faq.php
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Senior Member
Charles, be sure to check the Start-U site for an instructor in your area and take the basic training class if you can swing it. It will give you a year or so jump on folks that haven't had the training.
Welcome to the forum
Member
It's a pretty steep learning curve, at least it was for me. But what a ride! These guys are great. They are always willing to help. This forum is what you paid for, the machine was just a bonus.
Sometimes I'm just totally underwhelmed!
Series "A" Craftsman with Carvetight.
Posting Permissions
Reply With Quote