Question from trying to follow the tutorial projects

[dltccf]

I'm currently in project 4 of the tutorial projects where you are creating the rectangle with the curved edges. I have created the two sides and then used the arc tool to join them. They are lined up and snapped to the grid and look like I should have one big joined object, even when I zoom in on the corners, but I can't get the cut path tool to enable to indicate I have a closed region. How to I fix?

[fwharris]

select from the view tab the "toggle non end points" and see if any of the control points show up. If you have any open ones they will show.

[lynnfrwd]

I'm currently in project 4 of the tutorial projects where you are creating the rectangle with the curved edges. I have created the two sides and then used the arc tool to join them. They are lined up and snapped to the grid and look like I should have one big joined object, even when I zoom in on the corners, but I can't get the cut path tool to enable to indicate I have a closed region. How to I fix?

It might also be easier to find if you temporarily turn off the snap to grid. Particularly, if you drew a line then turned on snap to grid and tried to match it with another.

[dltccf]

select from the view tab the "toggle non end points" and see if any of the control points show up. If you have any open ones they will show.

Thanks, I found a video tutorial in another thread that said the same thing and it works.

[dltccf]

Thanks, I found a video tutorial in another thread that said the same thing and it works.

It was the AskBud downloads http://www2.wcoil.com/~nharbison/cw-...0downloads.htm so Thanks Bud also.