Can anyone help me with this project.

[rickbull]

I have a project that I cannot figure out. I have attached the project in hopes that someone can tell me how to make it work the way that I want.
As you can see, there are three arcs (arc1, arc2, and arc3)
I want to be able to set Arc3 to a depth of .063 and then cut out between Arc1 and Arc2 (or just cut out around Arc2)
Whenever I set Arc1 to be "pierced", everything between Arc1 and Arc3 disappears.
If I set Arc2 to a depth of 0, Arc3's recessed area seems to disappear.

Any of you gurus know how to make this work?

Thank you
Rick

[fwharris]

Rick,

Not sure if this is what you are asking for or NOT!

mpc "A"... arcs 1 and 2 carve region depth at "0",arc 1 (outer) set to pierce, both merge additive. Tabs need to be applied to hold the piece in the board.

mpc "B"... arc 2 I just applied the cut out tool....