Originally Posted by
temler
hi again
why is my machine now decided all boards are 5" thick, i think it is a sensor issue but not for sure and thought one of you might have seen this before,
Thanks
Tim
Not sure what you mean your machine always reads your board is always 5 inches thick?
Did you set you MPC to 5 inches? Really need to see you MPC.
Using Designer Version 1.187
Donations are always welcomed, thanks – send a check to my PO Box 652
BJB
PO Box 652
Yellville,AR 72687-0652
PM me for my e-mail address.