OK............ here we go again............ the infamous....... Error Code E06-313. It's on the initial setup of a project (using a board .5x5x24). Measuring of the board go fine with the CW. Asks for the 1/8 cutting bit. Does fine on the pad side then goes to the kick plate and all is fine. Returns to the pad side, goes up & down by the brass roller and all is fine. Goes to the other side of the board and goes down... all fine. Raises up and moves over to touch the metal.. touches it and LOCKS in the down position (and it snickers I know) and spits out the Error Code. I've cleaned and recleaned everything. I've changed cutting bits even though I've been using the one forever. I pushed the bit up in to the chuck (have a Rock Chuck) adapter till it's flush with the top part of the adapter that goes in to the Rock Chuck. I've pulled the bit out making it longer (just to see if it MIGHT make a difference) and still get the same error code. I've changed boards (using masking tape on all) and checked to make sure they're flat, straight and all is good. Is there anything else I can try? I tried cussing, but that just made me bang my finger so I apologized to the man upstairs for doing that. So........ I ask help from all the Obie Wahn Kanobies out in CW Forum land......... please. JerryB
JerryB:.
CarveWright START U Team Member
Using 1.187, Conform, PE/Probe, Centerline.
"Let's start sharing PTNs instead of MPCs so ALL SW versions can view & share"