Things to buy while in Houston

[gregsolano]

So I am going to the conference and I figure now is the time to buy all the little replacement things I will need and save on shipping.

I have a C machine which I bought used and it has a little over 100 hours on the motor. In the past I have seen posts about replacing brushes, certain bearings etc at certain hour intervals. What things should I purchase just to have on hand for the future while I am at the conference?

[SteveEJ]

Sandpaper belts if you have not upgraded. I am not sure if the 'C' machine has the new rubber belts or not. Bearings, brushes, bits and any thing else you think might get worn out.

[gregsolano]

I have the rubber belts and the brushes I was going to get, but which bearings?

[lynnfrwd]

This is a GREAT THREAD! Mary will be operating the CW Store at the conference and this will help her know what inventory to have on hand.

We will have sale pricing and NO SHIPPING, but we do have to charge taxes..... .... ...I know!!!!...but it's the LAW!!!!...8.25%.

[gregsolano]

This is a GREAT THREAD! Mary will be operating the CW Store at the conference and this will help her know what inventory to have on hand.

We will have sale pricing and NO SHIPPING, but we do have to charge taxes..... .... ...I know!!!!...but it's the LAW!!!!...8.25%.

Don't forget my commission on items sold from this thread! LOL

[skeeterman]

Cut motor brushes, FFC cables, board sensor, board sensor cables are a few that I am wanting to buy while there
Steve

[lynnfrwd]

Mary!!! You have some more things to add to your inventory list!!!

[chebytrk]

Don't forget to lay out some Roller Belts. I need some.

[lynnfrwd]

We will have both sandpaper & heavy duty.

[fwharris]

Cutting and carving bits (1/16, 3/16, 1/, motor brushes, replace cut motor (have one with cracked case @ flex shaft connection bringing bad one to change out), ribbon cables, X and Y belts..................