Hi Guys,
I recently purchased the treasure chest project from the website and have a question about carving it. The instructional PDF states I should use a MPC file to do a pre-carve on the 5/4 top, however the download does not contain this file. Has anyone carved this project and done the 5/4 top without the additional file? I called LHR and they told me they also do not have the file mentioned in the PDF, I fear trying to carve the final file without the pre carving file, I really dont want to break a bit on this or ruin an expensive board.
This is from the PDF file
For the
5/4 top insert, because this is a deep carve, use
the TC_topins_pass1.mpc to pre- carve both sides first,
then use the TC_topins_5q.mpc to do the final carve.
I am missing the TC_topins_pass1.mpc file
Thanks for the help
Nick