Junior Member
Will not find BIT!!!
If anyone can help!!!!!!!!!!!.......I put a new Z TRUCK in my CARVEWRIGHT machine with the ROCK CHUCK and now it will not find the bit.
It goes across to the right side and goes down, but it does not go down far enough to touch the POP OUT plate that sticks out!!!!
If anyone can help...please email me!!!
MANnWranglers@hotmail.com
Thanks,
G.Taylor
In Memoriam
What bit do you have in the chuck?Originally Posted by mannwranglers
AskBud
AskBud Downloads =>> CLICK HERE
Lesson added 7/15/2012 Titles begin with "2D-3D Build a Pattern-Part-3"
CW Vacuum Head Project =>> CLICK HERE
AskBud Home Page =>> CLICK HERE <<=PC lessons or CW lessons
More than 1250 AskBud patterns vvv-CLICK BELOW-vvv
http://store.carvewright.com/manufac...ufacturerid=29
Senior Member
Sounds like there is not enough of the bit outside of the rock. Normal should be about as much bit hanging out of the rock as when you had the QC and the bits had the collet on them.
Using Designer 1.187, STL importer, Center line, conforming vectors, scanning probe/PE, and the ROCK chuck.
Eddie
Senior Member
I think I would start looking at the cables. Maybe? Check for shorts?
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
In Memoriam
This is simple but it happened to me a couple of times so I mention it just in case. Ensure that you do not have your bit too far up in the chuck.
_________________________________
All the best!
Robert
Visit my company and/or church web page:
My Company Site My Company Blog My Church Blog My Church Website My Patterns
Posting Permissions
Reply With Quote