Results 1 to 4 of 4

Thread: Cork Board Frame

  1. 01-12-2007 #1
    Tim
    Tim is offline Junior Member
    Join Date
    Oct 2006
    Location
    Chattaroy, Washington
    Posts
    2

    Default Cork Board Frame

    This is a frame I made for my son in a very quick project- only took 15 minutes in the software and about 12 minutes of carving time per side. The interior cork is just under 2' x 3', just the right size to hold a store-bought inexpensive bulletin board. The frame is only $4 worth of pine with golden oak stain and then polyurethane on it, but it jazzes up the board a lot...
    Attached Thumbnails Attached Thumbnails frame_bb_627.jpg  
    Tim
    Reply With Quote Reply With Quote
  2. 01-12-2007 #2
    BobHill's Avatar
    BobHill
    BobHill is offline In Memoriam
    Join Date
    May 2006
    Location
    Tampa Bay Florida
    Posts
    1,400

    Default

    Another good idea <g>
    Reply With Quote Reply With Quote
  3. 01-19-2007 #3
    MacCarving
    MacCarving is offline Junior Member
    Join Date
    Jan 2007
    Location
    Florida
    Posts
    8

    Default Nice

    Very nice. If the frame could fit into the CW, could you make it one solid piece?
    Reply With Quote Reply With Quote
  4. 01-19-2007 #4
    BobHill's Avatar
    BobHill
    BobHill is offline In Memoriam
    Join Date
    May 2006
    Location
    Tampa Bay Florida
    Posts
    1,400

    Default

    Sure you could, Mac, but one side would be limited to less than 14½" and most would like the cork board a bit larger. besides, cutting the angles and edges for a proper fit etc. makes it a better challenge <g>.

    Bob
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. Book frame
    By liquidguitars in forum Projects Gallery
    Replies: 32
    Last Post: 03-13-2007, 03:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules