Does anyone know if the 3/16 bit is a 1/4 inch bit, in other words will it fit in the rock chuck once the sleeve is "depressed"?
Does anyone know if the 3/16 bit is a 1/4 inch bit, in other words will it fit in the rock chuck once the sleeve is "depressed"?
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
It is 1/4" then the hard pressed adapter takes it up to 1/2".
CarveWright CX Packaged System - starting at $2000
CarversClub 1 Year Subscription - $150.00/year
Adv. Support w/out CC membership - $25.00/issue
CarveWright Community Forum - PRICELESS!
The 3/16 bit is for the carvetight only.
Using 1.178
Yes it should be fine, I will be getting my first CT this week this will be fun to try...
Last edited by liquidguitars; 04-22-2011 at 11:53 AM.
So........how do you get the adapter off?
Custom Stadium Coin Racks for displaying Military Challenge Coins, GeoCoins and the like- http://www.etsy.com/shop/stadiumdisplays
OR http://shop.ebay.com/stadiumdisplays...&_trksid=p4340
I do not recommend pressing them off.. I have the 1/2" rock so CT bits fits like a dream..
I'm certainly looking forward to hearing how the CT bit works in the 1/2 rock-- thanks for taking the time to post this
Lawrence